The CS10 uses CR Magnetic's CR8459 Current Transformer to measure the approximate current over a range of 0 to 200 Amps. The CS10 outputs a millivolt signal allowing the transducer to be directly connected to the CR510, CR10X, or CR23X datalogger's. The CS10-L is intended for lower-accuracy applications such as motor or generator load conditions, efficiency studies, intermittent fault detection, and rough sub metering.


Model: CS10-L10
Quantity: 1
Condition: New (Overstock)
Warranty: 90 day (Factory)

Diviner 2000™, incorporating the proven technology of the EnviroSCAN sensor, accurately measures soil water content across the full range of soil moisture conditions. The patented Diviner 2000™ unique sensing portable probe is inserted into access tubes in the ground which have been installed with minimum disruption to the soil profile.


Model: 10100
Quantity: 1
Condition: Used, Good (Demo Unit)
Warranty: 90 day (IEI)

The Enviro-Systems Model SE-105S Ver 2 Smart Shaft Encoder is the same as the SE-105S but may be ordered with a 4-20mA output. An RS-485 output with SDI-12 software protocol is available and replaces the SDI-12 output.


Model: SE-105S
Quantity: 1
Condition: New (Demo Unit)
Warranty: 90 day (IEI)

The Enviro-Systems Model SE-109 Smart Shaft Encoder is a low power, computerized shaft encoder designed for battery powered field operation for the measurement of water level, precipitation, or flood gate position. The internal microprocessor allows the encoder to emulate an absolute encoder. Switches for setting and adjusting the stage (water) level, the SDI-12 address and shaft rotation increment direction are located beneath a protective cover on top of the encoder. A 6-digit LED display is provided on the top face for viewing data at the site location. The SDI-12 serial output is compatible with many data loggers, or may be sent directly to a PC computer through an Enviro-Systems SDI-12 to RS-232 converter. The Model SE-109 Encoder operates with standard float tape, bead chain pulleys and float hardware.


Model: SE-109
Quantity: 1
Condition: New (Inhouse Demo Unit)
Warranty: 90 day (IEI)

The CS431, manufactured by Instrumentation Northwest for use with Campbell Scientific datalogger's, measures both water level and water temperature. It uses piezoresistive strain gage technology to measure water level and an on-board thermistor to measure water temperature.


Model: PS9805-15
Quantity: 1
Condition: New (Demo Unit)
Warranty: 90 day (IEI)

These probes can be plugged directly into the external input jacks of H8 or U12 Family loggers to measure temperature in air, water, or soil.


Model: TMCI-HA
Quantity: 9
Condition: New (Overstock)
Warranty: 12 month (IEI)

Height of point: 7.5" (191 mm)
Material: Stainless steel
Size: 4" Dia x 9" H (102 mm x 229 mm)
Weight/shipping: 6.6 lbs/10 lbs (3.0 kg/4.5 kg)


Model: 255-205
Quantity: 2
Condition: New (Overstock)
Warranty: 12 months (IEI)

The Model 260-2501 Tipping Bucket Rain Gauge was designed for the National Weather Service to provide a reliable, low-cost tipping bucket rain sensor. Its simplicity of design assures trouble-free operation, yet provides accurate rainfall measurements. The tipping bucket mechanism activates a sealed reed switch that produces a contact closure for each 0.01", 0.25 mm, or 1 mm of rainfall. The gauge has an 8" orifice and is manufactured of powder coated and anodized aluminum. The funnel screen prevents debris from entering the gauge. Shipped complete with mounting brackets and 25' of signal cable.


Model: 260-2501
Quantity: 1
Condition: New (Overstock)
Warranty: 90 days (IEI)

The Temperature/RH smart sensor is designed to work with the HOBO Weather Station logger and the HOBO LCD logger with external probe input. All sensor parameters are stored inside the smart sensor, which automatically communicates configuration information to the logger without any programming, calibration or extensive user setup.


Model: S-THA-M002
Quantity: 2
Condition: New (Overstock)
Warranty: 12 month (IEI)

Surf safe Case for H09-002-08 (replacement HOBO Shuttle Case, Clear)


Model: 85-BOX-SS-CLR
Quantity: 2
Condition: New (Overstock)
Warranty: none

Black replacement HOBO shuttle Cases


Model: EVENT-CASE
Quantity: 2
Condition: New (Overstock)
Warranty: none

The SDM-SIO4 has four configurable serial RS-232 ports that communicate with intelligent serial sensors, display boards, printers, satellite links, and other serial devices. Once programmed, the SDM-SIO4 communicates with devices connected in parallel with the datalogger's own program sequence, thus making the complete datalogging system faster and more efficient. A multi-tasking operating system allows concurrent transmission and receipt of data on all ports.


Model: SDM-SI04
Quantity: 1
Condition: Used, Excellent (Customer Exchange)
Warranty: 12 month (IEI)

The 229-L Water Matric Potential Sensor measures soil water potential from 0.1 to 10 bars. The sensor consists of a heating element and thermocouple placed in epoxy in a hypodermic needle, which is encased in a porous ceramic matrix.


Model: 229-L10
Quantity: 10
Condition: New (Overstock)
Warranty: 12 month (Factory)